...with the necessary LINK OUT cascade port . Using the LINK OUT port , the video and audio signals are transferred via CATx cabling to the next receiver . This receiver can then drive its own dual display / speaker sets as well as provide a furth...
...Monitor Names link . On the subsequent page , enter the Environmental Monitor name in the appropriate field and press Apply . Creating descriptive sensor names : Click on the Sensor Names link . On the subsequent page , enter the sensor na...
...Technologies , Inc . TOSLINK is a registered trademark of Kabushiki Kaisha Toshiba dba Toshiba Corporation . Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners . Disclaimer : Black Box Network S...
...16 - port DVI ( single link ) and USB KVM switch with USB / DVI console with optional VGA output . • Unit is 2U high . ® ® • Supports Microsoft IntelliMouse ( Pro ) . • Operating system independent and transparent to all applications . • Switch wit...
...4K @ 60Hz DDC Link Training Input Equalization Automatic Input Cable Length Up to 20 ft . Output Cable Length Up to 20 ft . USB Signal Type USB 1.1 and 1.0 Keyboard and Mouse only . USB 2.0 for CAC connection . Type A to B ( 4 ) USB Type -...
...10 / 100 Mbits / sec Link ( LED ) Off = Network connection not detected On = Network connection detected Flashing = the device is sending or receiving data over this port 100 ( LED ) Off = 10 Mbits / sec connection On = 100 Mbits / sec connection...
...B1 ” provides the link to the next Control Module in the chain . Port A1 JB5 Port B1 Figure 3 - 1 . Jumper locations on the Control Module’s rear card . As shown in Figure 3 - 1 , there are five jumpers on the Control Module’s rear card , but ...
...1 ) Power LED , ( 1 ) Link LED , ( 40 ) LEDs ( Status and Online ) for ( 20 ) dry contacts ; EME149D - 20 , EME149D - 60 : ( 122 ) LEDs : ( 1 ) Power LED , ( 1 ) Link LED , ( 120 ) LEDs ( Status and Online ) for ( 60 ) dry contacts Temperature Tol...
...synchronize multiple , linked devices . In Synchronize mode , the ServSwitch 4site sends all settings changes as DCP messages . Thus , a chain of linked ServSwitch 4site units can be controlled synchronously . Important : When Synchronize mode is f...
Sign in
